EPDM Roofing Systems

Ethylene Propylene Diene Monomer, aka “Rubber Roof”

  • Flexible & Lightweight
    • Reinforced Available
    • 45/60/90 Mil. Thicknesses
  • Easily Repaired
  • Excellent UV Resistance
  • User Friendly Installation
  • Little or no Future Maintenance

EPDM, Ballasted – The ballasted system presents an easy, economical roofing solution for buildings that can accommodate an average ballast weight of 10 to 12 psf. Because the system is easy to install, it’s ideal of applications where eventual changes in building height or contours are envisioned.

EPDM, Mechanically Attached – This system presents a lightweight, cost-effective option if you wish to limit the weight load on the building or to reinforce an existing roof. Insulation, when necessary, is mechanically attached to the deck, with the membrane affixed at set intervals using linear attached batten strips to protect against wind uplift.

EPDM, Fully Adhered – This system is especially recommended for applications over an existing substrate where the use of mechanical fasteners is undesirable, or unfeasible. The insulation is installed using hot asphalt, with the membrane fully adhered to the secure insulation. The system may also be installed over insulation that is attached using conventional fastening methods where applicable. It’s also ideal for special configurations such as domes and barrels.